Dependence of cavitation bubble impact onto a body on liquid pressure

A. A. Aganin ; T. S. Guseva ; L. A. Kosolapova ; N. A. Khismatullina

Učënye zapiski Kazanskogo universiteta. Seriâ Fiziko-matematičeskie nauki, Uchenye Zapiski Kazanskogo Universiteta. Seriya Fiziko-Matematicheskie Nauki, Tome 161 (2019) no. 2, pp. 165-180

Résumé

The effect produced by liquid pressure during the impact of a cavitation bubble on the surface of a body was numerically studied. The liquid under study was water; the material of the body was copper-nickel alloy; the bubble was initially spherical (radius $1$ mm), touched the body, and filled with vapor in the saturation state. The liquid pressure $p_L$ varied from $1$ to $7$ bar. The impact on the body resulted from the action of a cumulative jet arising on the surface of the bubble during its collapse. The main attention was paid to the short-term initial phase of the impact when the maximum pressure on the wall was of the order of the water hammer pressure $p_{wh}$, corresponding to a rigid wall. It was shown that the cumulative jet velocity and radius increase from $115$ to $317$ m/c and from $38$ to $43\,\mu$m, respectively, with increasing $p_L$. Throughout the $p_L$ range considered, the initial stage of the cumulative jet impact developed similarly to the known case of the spherical drop impact. The body surface pressure first reached the water hammer pressure level. Then the pressure on the body surface at the center of the impact domain decreased monotonically, whereas at the periphery it initially increased to about $2.5 p_{wh}$ and after that decreased. Initially, the deformations in the body in the impact center vicinity were elastic at $p_L = 1$ bar and plastic at $p_L = 4$ and $7$ bar. Then they became plastic at $p_L = 1$ bar. With increasing $p_L$, the plastic zone significantly increased, its geometry greatly changed. The jet impact resulted in a circular micropit appearing on the body surface. With increasing $p_L$, it became more pronounced.

Détail

Mots-clés : cavitation, cumulative jet
Keywords: bubble collapse near body, liquid impact onto body, elastic-plastic body dynamics.

Bibliographie

[1] Kornfeld M., Suvorov L., “On the destructive action of cavitation”, J. Appl. Phys., 15:6 (1944), 495–506 | DOI

[2] Preece C. M., “Cavitation erosion”, Erosion, ed. Preece C. M., Acad. Press, N. Y., 1979, 208–301

[3] Arndt R. E. A., “Cavitation in fluid machinery and hydraulic structures”, Annu. Rev. Fluid Mech., 13 (1981), 273–328 | DOI

[4] Brennen C. E., Hydrodynamics of Pumps, Oxford Univ. Press, 1994, 293 pp.

[5] Terwisga T. J. C., Wijngaarden E., Bosschers J., Kuiper G., “Cavitation research on ship propellers a review of achievements and challenges”, Int. Shipbuild. Prog., 54:2–3 (2007), 165–187

[6] Ohl C.-D., Arora M., Ikink R., Jong N., Versluis M., Delius M., Lohse D., “Sonoporation from jetting cavitation bubbles”, Biophys. J., 91:11 (2006), 4285–4295 | DOI

[7] Skolarikos A., Alivizatos G., de la Rosette J., “Extracorporeal shock wave lithotripsy 25 years later: Complications and their prevention”, Eur. Urol., 50:5 (2006), 981–990 | DOI

[8] Guoa Sh., Khoo B.Ch., Teob S. L., Lee H. P., “The effect of cavitation bubbles on the removal of juvenile barnacles”, Colloids Surf., B, 109 (2013), 219–227 | DOI

[9] Brennen C. E., “Cavitation in medicine”, Interface Focus, 5, no. 5 (2015), 12 pp. | DOI

[10] Mason T. J., “Ultrasonic cleaning: An historical perspective”, Ultrason. Sonochem., 29 (2016), 519–523 | DOI

[11] Bourne N. K., “On impacting liquid jets and drops onto polymethylmethacrylate targets”, Proc. R. Soc. A, 461 (2005), 1129–1145 | DOI

[12] Shaw S. J., Jin Y. H., Schiffers W. P., Emmony D. C., “The interaction of a single laser-generated cavity in water with a solid surface”, J. Acoust. Soc. Am., 99:5 (1996), 2813–2824 | DOI

[13] Isselin J.-C., Alloncle A.-P., Autric M., “On laser induced single bubble near a solid boundary: Contribution to the understanding of erosion phenomena”, J. Appl. Phys., 84:10 (1998), 5766–5771 | DOI

[14] Aganin A. A., Guseva T. S., Kosolapova L. A., Malakhov V. G., Khismatullina N. A., “Modeling of cavitation bubble impact on a body”, Izv. UNTs Ross. Akad. Nauk, 2014, no. 2, 53–61 (In Russian)

[15] Aganin A. A., Guseva T. S., Kosolapova L. A., Khismatullina N. A., “The calculation of weakly nonspherical cavitation bubble impact on a solid”, IOP Conf. Ser.: Mater. Sci. Eng., 158:1 (2016), 012003, 6 pp. | DOI | MR

[16] Aganin A. A., Kosolapova L. A., Malakhov V. G., “Numerical simulation of the evolution of a gas bubble in a liquid near a wall”, Math. Models Comput. Simul., 10:1 (2018), 89–98 | DOI | MR

[17] Aganin A. A., Guseva T. S., “Numerical simulation of impact of a jet on a wall”, Math. Models Comput. Simul., 9:5 (2017), 623–635 | DOI | MR | MR | Zbl

[18] Aganin A. A., Khismatullina N. A., “Computation of two-dimensional disturbances in an elastic body”, Uchenye Zapiski Kazanskogo Universiteta. Seriya Fiziko-Matematicheskie Nauki, 159, no. 2, 2017, 143–160 (in Russian)

[19] Plesset M. S., Chapman R. B., “Collapse of an initially spherical vapour cavity in the neighbourhood of a solid boundary”, J. Fluid Mech., 47:2 (1971), 283–290 | DOI

[20] Philipp A., Lauterborn W., “Cavitation erosion by single laser-produced bubbles”, J. Fluid Mech., 361 (1998), 75–116 | DOI | Zbl

[21] Voinov O. V., Voinov V. V., “On the scheme of a collapsing cavitation bubble near the wall and the formation of a cumulative jet”, Sov. Phys. Dokl., 21:1 (1976), 133–136

[22] Blake J. R., Taib B. B., Doherty G., “Transient cavities near boundaries”, J. Fluid Mech., 170 (1986), 479–497 | DOI | Zbl

[23] Aganin A. A., Ilgamov M. A., Kosolapova L. A., Malakhov V. G., “Dynamics of a cavitation bubble near a solid wall”, Thermophys. Aeromech., 23:2 (2016), 211–220

[24] Aganin A. A., Guseva T. S., Kosolapova L. A., Malakhov V. G., “Shock waves in liquid under the pulsed action of a cavitation bubble on a rigid wall”, Uchenye Zapiski Kazanskogo Universiteta. Seriya Fiziko-Matematicheskie Nauki, 157, no. 2, 2015, 5–19 (In Russian) | Zbl

[25] Aganin A. A., Guseva T. S., Kosolapova L. A., “Impact of a cavitation bubble on a wall”, Russ. Aeronaut., 60:3 (2017), 391–397 | DOI | MR

[26] Aganin A. A., Guseva T. S., “Numerical simulation of the dynamics of non-uniform compressible media based on the CIP-CUP method on dynamically adaptive soroban grids”, Uchenye Zapiski Kazanskogo Universiteta. Seriya Fiziko-Matematicheskie Nauki, 156, no. 2, 2014,, 55–71 (in Russian) | Zbl

[27] Yabe T., Xiao F., Utsumi T., “The constrained interpolation profile method for multiphase analysis”, J. Comput. Phys., 169:2 (2001), 556–593 | DOI | MR | Zbl

[28] Yabe T., Wang P. Y., “Unified numerical procedure for compressible and incompressible fluid”, J. Phys. Soc. Jpn., 60:7 (1991), 2105–2108 | DOI

[29] Takizawa K., Yabe T., Tsugawa Y., Tezduyar T. E., Mizoe H., “Computation of free-surface flows and fluid-object interactions with the CIP method based on adaptive meshless Soroban grids”, Comput. Mech., 40:1 (2007), 167–183 | DOI | MR | Zbl

[30] Aganin A. A., Khismatullina N. A., “Schemes of the second order accuracy for computing the dynamics of disturbances in an elastic body”, Tr. Inst. im. R.R. Mavlyutova Ufim. Nauchn. Tsentra Ross. Akad. Nauk, 12:1 (2017), 44–50 (in Russian) | Zbl

[31] Il'gamov M. A., Gilmanov A. N., Non-Reflecting Conditions on the Boundary of Computational Domain, Fizmatlit, M., 2003, 240 pp. (in Russian)

[32] Wilkins M. L., “Calculation of elastic-plastic flow”, Methods in Computational Physics, Acad. Press, New York, 1964, 211–263

[33] Rein M., “Phenomena of liquid drop impact on solid and liquid surfaces”, Fluid Dyn. Res., 12:2 (1993), 61–93 | DOI

[34] Lesser M. B., “Thirty years of liquid impact research: A tutorial review”, Wear, 186–187:1 (1995), 28–34 | DOI

[35] Field J. E., “ELSI conference: invited lecture Liquid impact: theory, experiment, applications ”, Wear, 233–235 (1999), 1–12 | DOI